You were right I found a old board with a SD card holder I solder it in place of sd adapter and sd boot was ok.
Everything is fine the pairing is resolved.
Thanks for help.
Yes most of the time it's blank when I try to boot on SD card.
When I boot normally I always have a display and the NAND boot error.
I tried both sd card 4GB and 16GB.
I will try another software to burn image (I used win32diskimager as you suggested).
Yes the resistor is only on TP1. 3v3...
Hi,
I am trying to fix my drone with a pairing issue.
So I plug my laptop to the serial debug port and I can see the famous error NAND boot failed.
So I have soldered a micro sd adapter on the arm board where there is a empty micro sd card location.
But the drone won't boot on sd card (I put...
Hi,
Hi, I am french and I am new on the forum and in the drone universe :)
I do electronic as hobby and I have a drone karma gopro with the pairing issue.
I will post a message on the appropriate forum.
Best regards,
Eric
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.