Recent content by edk160

You need the small 3 pin connector next to label "DM_368". Gimbal side upfront facing, then upper pin = Ground (GND) signal for serial port to the laptop. Middle pin is TxD (Transfer Data) from drone to laptop. Bottom pin = RxD (Receive data) from laptop to drone. Speed Baudrate in Putty set...

Is the barometer prone to fail suddenly ? If so, I probably need to buy some for spare, just in case. And a hot air rework station :)

Thank you for sharing this solution ! Do you know if there is hardware schematic of the Karma Drone available somewhere ? And also hardware schematic of the controller ? How did you de-solder the old barometer and solder the new barometer onto the mainboard ? With hot air? or very fine...

Sometimes it is necesarry to try another microSD card, from another brand, of you will. The initialisation procedure for (micro)SD cards is not always working perfect for some SD cards. Another SD card can fix this. I did not use the resistor because a standard MicroSD card needs 3.3 Volt at...

Hi, My MD5 checksum is: MD5 hash of Karma_boot_SD.img: a40e5a7800a98e7ccce184e34b554751