Recent content by Boko

Unfortunately I don't know where the schematic is. I recognized Burro because of its unique appearance. I used a heat gun to remove it, but it was very difficult.

I replaced baro and it was fixed. MS5611 https://a.aliexpress.com/_ombIIYO

Although I succeeded in rewriting the boot sector, I got an error message saying that I couldn't take off due to an abnormality in baro.I peeled it off with a hot plate from a certain module and pasted it, and it worked. GY-63 MS5611-01BA03 https://a.aliexpress.com/_olMY2Ow

update mwrite store data normal 0x51bf0000 data.img

I was able to connect and control both the original controller and the data-copied controller to the drone.

The controller that was blacking out after the startup screen has been fixed. A saved map has been copied. However, the new map is about 70% downloaded and a message appears saying that it could not be saved and please check your wifi.

The controller that was blacking out after the startup screen has been fixed. Even the pairing number has been copied

I don't have an ev2300 do I need to buy one

Check it out with the next app that had bq40z50 on the board

the battery is charged if I insert it into the charger and it also acts as a powerbank to the controller I2c sda scl rst Is there any way I can unlock it?

MS5611?

I can't find Baro on the board. [0946684914.143] Commander: arm_disarm: arm requested [0946684914.144] Commander: Sending arm request [0946684914.144] Commander: request_arm_disarm: arm: 1 force: 0 arm_status: 0 [0946684914.146] Commander: requesting IDLE state [0946684914.147] Commander...

BARO probrem? nsh> : nh:[K84866. noound nsh: :: command not found nsh> nsh> t fou [0946684866.875] t: Available Tests [0946684866.876] t: batt_auth host - batt_auth test [0946684866.883] Health...

3) Flash the remaining blocks, (except the "manufacturer" - there serial numbers, "Black box", "reserved") Please tell me the command to do this

After this I updated to 2.50.1